35
Victory Viper
ASSEMBLY
1. Position the scooter halves as shown in figure 23.
2. Lift up on the frame handle and push back on the seat post.
3. Align the curved bracket of the front section with the mounting peg of the rear section and lower the
front section onto the pin of the rear section.
4. Pivot the front and rear sections towards each other. The locking pin will lock into place.
5. Place the batteries into the battery wells, and fasten the battery straps.
6. Plug both black and white battery harnesses in.
7. Plug the large, white, 9-pin front-to-rear connector into its mating plug coming from the rear.
8. Reconnect the handbrake cable by sliding the cable into its slot on the brake mount. With your thumb,
push forward and hold the brake release lever, then slide the cable release hook onto the peg and gently
let go of the brake release lever.
9. Plug the lighting harnesses back into their connectors before fully reinstalling the rear shroud.
10. Reinstall the seat.
FRAME LOCK LEVER
9. Pull the frame lock lever all the way back. See figure 22.
10. While holding the lever back, lift up on the frame handle and push back on the seat post. The frame
halves will separate. See figure 23.
Figure 22. Frame Lock
Figure 23. Separating Frame Halves
CURVED BRACKET
MOUNTING PEG
V I I I . D I S A S S E M B L Y A N D A S S E M B L Y
