34
Victory Viper
The Victory Viper requires no tools for disassembly. Always disassemble or assemble your scooter on a
level, dry surface with sufficient room for you to work and move around your scooter. Keep in mind that
the disassembled sections of the scooter will take up more floor space than the assembled scooter.
DISASSEMBLY
1. Remove the key from the key switch.
2. Push down on the manual freewheel lever. See IV. Your Victory Viper. Putting your scooter in drive
mode may make it easier for you to maneuver the rear section because the drive wheels are stabilized.
3. Lift the seat up and off of your scooter.
4. Gently lift the rear shroud off of your scooter far enough to be able to disconnect the rear light har-
nesses. See figure 18. The rear shroud is held in place with a reusable fastener.
5. Unplug the large, white, 9-pin front-to-rear connector. See figure 19.
6. Unplug both battery harnesses from the battery harness connectors.
See figure 19.
7. Loosen the battery straps, then lift both batteries from the battery wells.
8. Disconnect the handbrake cable from the rear hub by pushing forward and holding the brake release
lever with your thumb. See figure 20. Lift the cable release hook free of the peg and slide the handbrake
cable free of its slot on the brake mount. See figure 21. Move the cable safely out of the way.
PUSH BRAKE RELEASE
LEVER FORWARD
Figure 20. Brake Release Lever
LIFT UP THE CABLE
RELEASE HOOK
BRAKE
MOUNT
HANDBRAKE
CABLE
Figure 21. Disengage Handbrake Cable
LIGHTING
HARNESSES
Figure 18. Disconnect Lighting Harnesses
FRONT-TO-REAR
CONNECTOR
BATTERY HARNESSES CONNECTORS
Figure 19. Front-To-Rear Cable
V I I I . D I S A S S E M B L Y A N D A S S E M B L Y
