Pride Rally shopper, Owner'S Manual

Page: 30 / 39

30 Rally Shopper
You can adjust the tiller to many positions. The tiller adjustment lever locks the tiller in place. It has a spring-loaded
mechanism that enables you to rotate it and change its position.
1. Turn the tiller adjustment lever counterclockwise until it is loose. If the tiller adjustment lever comes in contact
with the tiller basket, pull it outward, turn it clockwise, and release it. Continue to loosen until the tiller is able
to move. See figure 10.
2. Press the release buttons and move the tiller to a comfortable position.
3. Turn the tiller adjustment lever clockwise until it is tight. If the tiller adjustment lever comes in contact with the
tiller basket, pull it outward, turn it counterclockwise, and release it. Continue to turn the lever until it is tight.
The tiller may be lowered to the center of the floorboard and locked in place for storage.
SEAT HEIGHT ADJUSTMENT
V I I I . C O M F O R T A D J U S T M E N T S
Figure 11. Seat Height Adjustment
UPPER SEAT POST
LOCATING HOLES
BALL DETENT PIN
Figure 10. Adjusting The Tiller Angle
TILLER ADJUSTMENT
LEVER
RELEASE
BUTTONS
SLIDE LEVER OUT
TO REPOSITION
LOWER SEAT POST
The seat can be repositioned to one of three different heights.
See figure 11.
1. Push forward on the seat lock lever and lift the seat up
and off of the scooter. See figure 12.
2. Use the attached ring to pull and remove the ball detent
pin from the lower seat post.
3. Raise or lower the upper seat post to the desired seat
height.
4. While holding the upper seat post at that height, match up
the holes in the upper seat post with the holes in the lower
seat post.
5. Fully reinsert the ball detent pin.
6. Replace the seat.
WARNING! Remove the key from the key switch before adjusting the tiller or the seat.
Never attempt to adjust the tiller or the seat while the scooter is in motion.