Pride PATHRIDER ES10, Owner'S Manual

Page: 28 / 44

Pathrider ES 10 www.pridemobility.com 28
I V . B A T T E R I E S A N D C H A R G I N G
7. Connect the red battery cable to the positive (+) battery ter-
minal on each battery.
8. Connect the black battery cable to the negative (-) battery
terminal on each battery.
9. Reposition the terminal boots over the battery terminals.
10. Reconnect the battery harnesses.
11. Reconnect the battery tie-down straps.
12. Reinstall the battery shroud and seat.
NOTE: If you encounter a damaged or cracked battery,
immediately enclose it in a plastic bag. Contact your local
waste disposal agency or your authorised Pride Provider for
instructions on disposal and battery recycling, which is our
recommended course of action.
Why do my new batteries seem weak?
Deep-cycle batteries employ a different chemical technology than that used in car batteries, nickel-cad-
mium batteries (nicads), and other common battery types. Deep-cycle batteries are specifically designed
to provide power, drain down their charge and then accept a relatively quick recharge.
We work closely with our battery manufacturer to provide batteries that best suit your scooter’s specific
electrical demands. Fresh batteries are shipped fully charged to our customers. During shipping, the batteries
may encounter temperature extremes that can influence their initial performance. Heat diminishes the charge
on the battery; cold slows the available power and extends the time needed to recharge the battery.
It may take a few days for the temperature of your scooter’s batteries to stabilise and adjust to their new
room or ambient temperature. More importantly, it takes a few charging cycles (partial draining followed
by full recharging) to establish the critical chemical balance that is essential to a deep-cycle battery’s peak
performance and long life.
Follow these steps to properly break in your scooter’s new batteries for maximum efficiency and
service life:
1. Fully recharge any new battery prior to its initial use. This charging cycle brings the battery up to about
88% of its peak performance level.
2. Operate your new scooter in familiar and safe areas. Drive slowly at first, and do not travel too far from
your home or familiar surroundings until you have become accustomed to your scooter’s controls and
have properly broken in your scooter’s batteries.
3. Fully recharge the batteries. They should be at over 90% of their peak performance level.
4. Operate your scooter again.
5. Fully recharge the batteries again.
6. After four or five charging cycles, the batteries are able to receive a charge of 100% of their peak
performance level and are able to last for an extended period of time.
What about public transport?
If you intend to use public transportation with your scooter, you must contact the transportation provider
in advance to determine their specific requirements.
Figure 15. Battery Removal/Installation