US Jet 3 Ultra/RevC/Jun03
www.pridemobility.com
37
I X . C A R E A N D M A I N T E N A N C E
WARNING! Never use a rubber conditioner on the tread area of the tires; doing so may make the
tires slippery and cause your power chair to skid.
n
The body shroud has been sprayed with a clear sealant coating. You can apply a light coat of car wax to help it retain
its high-gloss appearance.
n
Check all electrical connections. Make sure they are tight and are not corroded. Batteries must sit flat within the battery
tray, with the battery terminals facing inward, toward each other. Refer to the battery wiring label for the correct wiring layout.
n
All wheel bearings are prelubricated and sealed. They require no subsequent lubrication.
Daily Checks
n
With the controller turned off, check the joystick. Make sure it is not bent or damaged and that it returns to the neutral
position when you release it. Check the rubber boot around the base of the joystick for damage. Visually inspect the
boot. Do not handle or try to repair it. See your authorized Pride Provider if there is a problem.
n
Visually inspect the controller cable. Make sure that it is not frayed, cut, or has any wires exposed. See your authorized
Pride Provider if there is a problem.
n
Check for flat spots on solid tires. Flat spots could adversely affect stability.
Weekly Checks
n
Disconnect and inspect the controller battery door. Look for corrosion. Contact your authorized Pride Provider if
necessary.
n
Ensure that all parts of the controller system are securely fastened to your power chair. Do not overtighten any screws.
n
Check for proper tire inflation. There should be
35 psi
in each tire (if equipped with pneumatic tires). If a tire does not
hold air, see your authorized Pride Provider for replacement of the tube.
n
Check the brakes. This test should be carried out on a level surface with at least three feet of clearance around your
power chair.
To check the brakes:
1. Turn on the controller and turn down the speed level of your power chair.
2. After one second, check the battery condition meter. Make sure that it remains on.
3. Slowly push the joystick forward until you hear the electromagnetic brakes click. Immediately release the joystick. You
must be able to hear each electromagnetic brake operating within a few seconds of joystick movement. Repeat this test
three times, pushing the joystick backwards, then left, and then right.
Monthly Checks
n
Check that the anti-tip wheels do not rub the ground when you operate the power chair. Adjust them as necessary. See
VI. Comfort Adjustments.
n
Check for extreme wear on the anti-tip wheels. Replace them as necessary.
n
Check for drive tire wear. See your authorized Pride Provider for repair.
n
Check the caster wheels for wear. Replace them as necessary.
n
Check the caster forks for damage or fluttering which indicates that they may need to be adjusted or have the bearings
replaced. See your authorized Pride Provider for repair.
n
Keep your power chair clean and free of foreign material, such as mud, dirt, hair, food, drink, etc.
