46
www.pridemobility.com
Jazzy 600
I X . C A R E A N D M A I N T E N A N C E
n
Check all electrical connections. Make sure they are tight and are not corroded. Batteries must sit flat within the battery
tray, with the battery terminals facing inward, toward each other. Refer to the battery wiring label for the correct wiring layout.
n
All wheel bearings are prelubricated and sealed. They require no subsequent lubrication.
Daily Checks
n
With the controller turned off, check the joystick. Make sure it is not bent or damaged and that it returns to the neutral
position when you release it. Check the rubber boot around the base of the joystick for damage. Visually inspect the
boot. Do not handle or try to repair it. See your authorized Pride Provider if there is a problem.
n
Visually inspect the controller cable. Make sure that it is not frayed, cut, or has any wires exposed. See your authorized
Pride Provider if there is a problem.
n
Check for flat spots on solid tires. Flat spots could adversely affect stability.
Weekly Checks
n
Disconnect and inspect the controller from the power base. Look for corrosion. Contact your authorized Pride Provider if
necessary.
n
Ensure that all parts of the controller system are securely fastened to your power chair. Do not overtighten any screws.
n
Check for proper tire inflation. There should be
35 psi (2.4 bar)
in each tire. If a tire does not hold air, see an authorized Pride
Provider for replacement of the tube.
n
Calibrate the joystick if a noticeable difference in performance is detected or if the joystick does not operate properly. To calibrate
the joystick, power off the unit, place the joystick in the neutral position, and power the unit back on. If a problem still exists with your
joysticks performance, contact your authorized Pride Provider.
n
Check the brakes. This test should be carried out on a level surface with at least three feet of clearance around your power chair.
To check the brakes:
1. Turn on the controller and turn down the speed level of your power chair.
2. After one second, check the battery condition meter. Make sure that it remains on.
3. Slowly push the joystick forward until you hear the electric brakes click. Immediately release the joystick. You must be
able to hear each electrical brake operating within a few seconds of joystick movement. Repeat this test three times,
pushing the joystick backwards, then left, and then right.
To calibrate the joystick (Remote Plus only):
1. Position the joystick in the full reverse position and hold it there. Turn on the controller.
2. The battery condition meter lights up from one light to ten lights, and then back to one light. It does this twice, then blinks rapidly.
3. Turn off the controller.
4. Position the joystick in the full forward position and hold it there; then turn the controller on.
5. The battery condition meter lights up from one light to ten lights, and then back to one light. It does this twice, then blinks once, and
then it blinks continuously.
6. Turn off the controller. Now the joystick and controller are set up to function properly together.
Monthly Checks
n
Check for drive tire wear. See your authorized Pride Provider for repair.
n
Check the caster wheels for wear. Replace them as necessary.
n
Check the caster forks for damage or fluttering which indicates that they may need to be adjusted or have the bearings
replaced. See your authorized Pride Provider for repair.
n
Keep your power chair clean and free of foreign material, such as mud, dirt, hair, food, drink, etc.
