Pride Jazzy 1402, Owner'S Manual

Page: 24 / 42

24 www.pridemobility.com Jazzy 1402
V . C O M F O R T A D J U S T M E N T S
COMFORT ADJUSTMENTS
Once you are familiar with the operation of your Jazzy 1402, there are some adjustments you can make to increase your
comfort, such as seat height and angle, armrest width, angle and height, joystick position, and footrest height, depth, and
angle. If your power chair is equipped with a Synergy Seat or a TRU-Balance Power Positioning System, refer to the
information provided in separate manuals. If your power chair is equipped with a contour seat, refer to the following
information.
WARNING! If your power chair was configured by your authorized Pride Provider, please consult
your healthcare professional before making any adjustment that may degrade your power chair’s
performance and safety by changing its center of gravity.
WARNING! Some power chair components are heavy. You may need assistance to lift or carry
them. Please refer to the specifications table for specific component weights before you
disassemble the power chair.
WARNING! Prevent injury. Remove the occupant from the power chair before making any
adjustments.
Figure 15. Seat Latch Safety (Disengaged)
Figure 16. Seat Height Adjustment
QUICK-RELEASE PINS
BALL DETENT PINS
You may need the following to make comfort adjustments:
„
metric/standard socket set and ratchet
„
metric/standard hex key set
„
adjustable wrench
Seat Height
The seat is attached to the power base through the UMS.
You can change the seat height by raising the front and
rear trapeze bars. If you raise or lower only one trapeze
bar (front or rear), you can also change the seat base angle
(dump).
To change the seat height:
1. Turn off the power to the controller.
2. Unplug the controller connector(s) from the electron-
ics tray.
3. Flip up the seat latch safety. See figure 15.
4. Squeeze the seat latch and release the seat from the
front trapeze bar.
5. Slide the seat forward and remove it from the power
base.
6. Remove the quick-release pins from the trapeze bars
(front and rear). See figure 16.
7. Remove both trapeze bars from the seat towers.
8. Lift off the shroud
9. Remove the ball detent pin from each of the four seat
towers. See figure 16.
10. Move the seat towers up or down to the desired height.
11. Reinstall the ball detent pin into each seat tower.
12. Reinstall the shroud.