Pride Mobility JET1, Owner'S Manual

Page: 23 / 37

23 Jet 1
V I I . O P E R A T I O N
Battery Condition Meter
The battery condition meter is located immediately behind the joystick. This enables you to monitor battery life.
The battery condition meter indicates the approximate amount of battery life left. See figure 24.
n Red, yellow, and green circles indicate that the batteries are fully charged.
n Red and yellow circles indicate that you should charge the batteries if possible.
n Red circles indicate that you should charge the batteries as soon as possible, because low battery voltage may
cause your Jet 1 to become inoperative.
NOTE: When the batteries begin to approach a discharged state, the first red bar will begin to flash slowly,
reminding you that the batteries need to be charged immediately!
Trouble Codes
In addition to indicating the current state of battery charge, the battery condition meter can also indicate possible
problems with your Jet 1. If the battery condition meter is flashing rapidly, the controller may be indicating a fault.
The meter has six individual circles. These circles are meant to provide information by the number of circles that are
flashing. For instance, trouble is encoded as one (for a low battery voltage) to six (for a motor stalled or joystick
out of neutral time out) and displayed by flashing all LEDs the number of times given by the trouble code. The
following is a list of the possible errors signified by the rapidly flashing meter.
Flash Code
Sequence Diagnosis Solution
•—•—•—
Low Battery Voltage Check Batteries/Battery Wiring
••—••—••—
High Battery Voltage Check Batteries
•••—•••—
Left Motor Disconnected Check Left Motor Wiring
••••—••••—
Right Motor Disconnected Check Right Motor Wiring
•••••—•••••—
Brake Connection Fault Check Motor/Brake Wiring
••••••—••••••—
Controller Fault See Authorized Pride Provider
•••••••—•••••••—
Motor Stalled or Joystick
out of Neutral Time Out Reset the Power On/Off Button
“•” means all 6 LED’s flash on for a period of 0,2 seconds and off for 0,8 seconds.
“—” means all 6 LED’s are off for a period of two seconds before flashing sequence repeats.
If you cannot resolve your problem, see your authorized Pride provider.