5
©2020 Production Resource Group, L.L.C. All Rights Reserved
Specifications are subject to change without notice. July2020
Connecting Power
AC Power
Connect the unit to a grounded AC power source of 100-240V 50/60Hz.
Note: The battery does not charge when the SmartXcan is connected to AC power.
Battery Power
Step 1. Unlock the battery door on the rear of the unit.
Step 2. Install a charged battery onto the battery mounting plate by sliding
the battery downwards onto a charging bay. Ensure the V-Mount rails
are aligned between the charger and battery.
Step 3. The battery is fully engaged when the latch makes an audible “click”
sound and is firmly seated.
PoE
for connecting to a PoE source.
Operating Modes
Standalone
The SmartXcan device will operate as-is without any additional network
or computer connections. This is the most simple and common operating
mode.
Networked
Optionally, the user may choose to connect the device to a single computer
or a computer network to perform any of the following (but not limited to):
+
Enable a simple Kiosk (monitoring) mode
+
Configure the device
+
For additional features, refer to the
Accessing SmartXcan Web Interface
Use the following steps to access the SmartXcan web interface
SmartXcan Web Interface Kiosk Window
Step 1. Set the IP address of the computer you wish to connect the
SmartXcan as stated below. Computer IP Address: 192.168.100.101
Subnet Mask: 255.255.255.0
Step 2. It is recommended to disable all other network sources of the
computer such as WiFi. Any firewalls should also be disabled.
Step 3. Open a web browser window and type in the IP address
192.168.100.223
Refer to the
for login and configuration information.
