PAGE
78
BEST BOY
®
HP SPOT LUMINAIRE
|
SERVICE MANUAL
|
MAINTENANCE
Step 13. To reinstall a new lead screw, carefully thread the new lead screw,
shaft end first, down through the lead screw nut. Once you’re
screwed in so that the exposed shaft begins to come in contact
with the bearing, hold onto the Lens carrier assembly and keep
threading to properly seat the lead screw.
Step 14. Once the lead screw is properly set back into the carrier, torque the
lead screw set screw to 2 in-lbs, and apply a drop of Loctite #425
to the threads.
Step 15. Reinstall the Group 3 Light Shield to the front of the fixture,
securing it with its four 10-32 x 1/2" Socket Cap screws.
Step 16. If you have touched any of the lens glass with bare fingers or you
see dirt on Lens Group 3, clean those surfaces according to the
procedures listed in this manual.
See "Cleaning Lenses" on
page 40.
Step 17. Clean the Front Glass panel and reinstall it onto the front of the
fixture, making sure that the ring is properly seated into its groove.
See "Replacing Front Glass" on page 54.
Step 18. Reattach the top and bottom cable bundles to the Light Shield
using the four zip ties installed onto the Light Shield.
See "Freeing Cable Bundles from Group 3 Light Shield" on page 76.
Step 19. Replace the Wheel Stack.
Step 20. Reinstall the Head Fan.
Step 21. Replace the Head Covers.
Summary of Contents for BEST BOY HP SPOT LUMINAIRE
