www.preval.com
Page 4
Test the vFan Airbrush by unscrewing glass jar and filling it half
way with water or solvent.
Take out the air hose and screw to the bottom of the airbrush.
Once secured, insert the metal tip (attached to the top of the
6-oz. glass product container) into the bottom fitting of the vFan
Airbrush at a 45 degree angle.
Open up the accessories bag and take out the pressure
regulator valve. The top of the regulator valve has a control knob.
Turn the control knob counter clockwise for off position.
Take out a unit of
150 Feet of ENERGY
and remove black top.
Remove red dusting unit by pulling away from the top. Screw
the pressure regulator valve to the top of the
150 Feet of
ENERGY
unit so it is snug.
Screw the other end of the air hose into the open side of the
regulator valve, ensuring it is snug.
The vFan Airbrush is ready to test spray. Turn the control knob
clockwise until it is all the way down. Push down the Airbrush
trigger and air pressure will be forced out from the aircap.
While holding the trigger down, pull back. The further you pull
back, the greater the volume of the product will flow. To adjust
air pressure, turn control knob counter clockwise. The can of
150 Feet of ENERGY
will freeze after 45 seconds of use. Sold
separately, use our EDU, page 9, for long lasting, continuous
spray needs.
Now that you have tested your unit for optimal results, it is time
to strain and thin your paints accordingly to thinning guidelines.
Clean after each use. Always release air pressure from air hose
by turning control knob counter clockwise when done.
The vfan PorTable airbruSh SySTem
8-step QuIck staRt
See our video directionS at: tinyurl.com/vfan-quickstart
1
4
2
5
7
3
6
8
