Presto Lifts Power Stak PPS2200-62NAS, Installation, Operation And Service Manual, Page: 8 / 60

PRESTO OWNER’S MANUAL
Page 8
POWER STAK
all personnel completely cleared from the area.
Pick the unit up approximately six inches above the
pallet or skid. Once raised, remove the pallet or skid
from below the lift. Do not move the lift around in the
air. Lower the stacker on the ground.
C. PREPARATION FOR USE
This stacker left our factory in new condition. It has
been inspected and weight tested to assure all perfor-
mance standards have been met.
Visually inspect the stacker for damage. Check for at-
tachments and accessories that may have been ordered.
If there is any damage or missing parts, report it to your
carrier and your Presto dealer immediately.
Remove all metal/plastic bands, cardboard and other
material used for shipping purposes.
Check to see if chains are in place, and that the lift
system is in working order. Inspect for oil leaks.
See instructions for removing back panel on pg. 5.
Connect battery cable. Check cables and wires on bat-
tery charger as well as battery.
Set up procedure for Power Stak Strad-
dle legs
NOTE: The Straddle legs must be adjusted to
the procedure below
1. Determine the required straddle leg dimension.
2. Relieve any weight from the legs. This may need to
be done one side at a time.
3. Adjust the legs and ensure both legs are positioned
equally.
Note: The Power Stak is meant to operate on a non
slip fl oor or surface. If traction is needed, Presto
Lifts offers an optional rubber wheel or a non-mark-
ing wheel.
Note: The travel speed is preset at the factory. For
travel speed adjustment, please contact customer
service at Presto Lifts 1-800-343-9322
Straddle Leg Bolt
Tightenting Procedure
1. Pre-tighten all bolts to
the bottom, but not too
tight.
2. Fully tighten bolt 1.
3. Next, tighten bolt 3.
4. Last, tighten bolt 2.
5. Tighten all bolts to 85
foot pounds.