128-9350
2 of 4
2
REMOTE TRUNK RELEASE
If you have electric trunk release in your vehicle and the remote trunk release option
was added to your vehicle, simply press and hold the Key/Trunk button of your
keychain transmitter for 4 seconds or until the electric trunk of your vehicle opens.
REMOTE STARTING THE VEHICLE
This unit will not start the vehicle if any one of the following situations exist:
The vehicle's hood lid is opened.
The gear shift selector is not in Park.
The brake pedal is depressed.
The safety control switch is in the OFF position.
1. To start the vehicle, press and release the Key/Trunk button two times within
2 seconds. The vehicle will start and remain running for the pre-programmed 5,
10, 15, 20 minute run cycle. As a visual indication, the parking lights will flash or
remain on depending on the setting by your installation center.
2. When you arrive at the vehicle, turn the ignition key to the ON position (not the
spring loaded start position), then step on the brake pedal to disengage the
remote starter. The vehicle will continue to run, but now on its own power.
NOTE:
The engine will stop running before the pre-programmed run cycle has
expired if you perform any one of the following functions:
- Press and release Key/Trunk button on the keychain transmitter two times within
2 seconds.
- Depress the brake pedal.
- Open the vehicle's hood.
- Place the unit in the safety control disabled mode.
PUSH-BUTTON LED RECEIVER VALET/OVERRIDE/SAFETY CONTROL
SWITCH
The Push-Button LED switch located in the receiver allows you to temporarily dis-
able the remote starting function of the system. This is recommended whenever
the vehicle is being serviced.
To place the system in the service mode:
1. With the system disarmed/unlocked, and the ignition switch off, press and hold
the Push-Button, found on the wind shield receiver, in.
2. Turn the ignition switch on, off, on, off, on, off.
3. The LED begins to flash two short flashes followed by one long flashes and
continues this pattern until returned to normal mode of operation. This puts
the unit into the R/S Override mode indicating that the remote start is in the
service mode and will not start from RF or any other input Posse or otherwise.
To Exit R/S Override Mode:
1. With the system disarmed, Press and Hold the Push-Button, found on the
windshield receiver, in.
2. Turn the ignition switch on, off, on, off, on, off.
3. The LED turns off, indicating that the R/S unit is fully functional one again.
