128-9480
15 of 16
Page 15
COMPLETING THE INSTALLATION:
After you have confirmed the operation of the Remote Start unit and tested all the safety
features of the system:
1. Mount the control module up and behind the dash securing it in place with cable ties
or screws. Be certain that the chosen mounting location will not inhibit any of the
controls of the vehicle.
2. Securely harness and tie all wiring up and away from all hot and moving parts that they
may come in contact with under the dash board or in the engine compartment areas.
CAUTION:
Particularly avoid the area around the steering shaft and column, as wires
can wrap around these mechanisms and impair the safe operation of the
vehicle.
3. Apply the Caution Labels supplied with this kit to a conspicuous area in the engine
compartment. Make sure to clean the surface before affixing the label.
4. Check the vehicle’s wipers, lights, horn, etc.... to insure proper operation.
5. Replace all panels that were removed during installation, and retest the system.
6. Explain all activated features and safety systems associated with Remote Start Unit
installed to the customer.
