7
Connect Drop-In Charger with AC adaptor
Plug one end of the AC adaptor into the wall outlet and
the other end into the drop-in charger.
The drop-in charger is not water proof. En-
sure the radio is dry before connecting to
the charger.
Don’t use the charger when the ambient
temperature is below 0º C (32º F) or above
45º C (113º F).
Install the Battery Pack
Your radio uses the supplied NiMH battery pack.
To install the NiMH battery pack:
1. Make sure the radio is off.
2. Turn the screw holding the battery compartment counterclockwise with a
screwdriver, and hold up the battery cover.
3. Put the NiMH battery pack in the battery compartment applying the battery
contacts to the lower charge contacts. Be sure to follow the instructions
written on the battery pack’s label. Installing the battery pack incorrectly will
prevent the unit from operating.
4. Before placing the battery cover back on the radio, check the rubber seal
around the battery compartment and the ribbon of the battery pack: make
sure that the seal is in good condition and that there is no foreign matter
under the seal.
5. Replace the battery compartment door. Tighten the screws securely.
If the rubber seal appears warn, nicked, or dried out, replace-
ment seals are available.
Use only the supplied NiMH battery pack. Do not charge alkaline
or non rechargeable batteries.
Attaching the Beltclip
To attach the belt clip:
Slide the belt clip until it snaps into place.
To remove the belt clip:
To remove the belt clip, press and hold belt clip locker, slide the belt clip at the
same time until released.
-
-