10
Long press
•VOX
key (
7
) key in order to
valid adjustments
and quit
the
Vox Adjustment
mode.
When
VOX SETTING
is done the
VOX
function is automati-
cally
ON
.
“VOX”
appears on the display.
8) WEATHER ~ ALERT ~ M1
WEATHER
(short press)
CB functions are not allowed in
WEATHER
mode. If user
presses a not allowed key and
KEY BEEP
function is acti-
vated, the radio sounds error tone.
Press
WEATHER
key (
8
) in order to activate the
WEATHER
mode.
“WEATHER”
appears on the display. A new short
press on
WEATHER
key (
8
) disables the
WEATHER
mode.
“WEATHER”
disappears.
The
WEATHER
mode allows to hear weather information.
When the mode is activated, use channel selector switches
to move through the 7 weather channels to find the active
channel in your local area.
ALERT
(long press)
The SIREN tone
only sounds in
CB
and
PA
mode. It does not
sound in
WEATHER
mode.
Press and hold
ALERT
key (
8
) for 1 second to activate/
deactivate the
ALERT
function. When the function is
on
and a tone is detected at the selected weather channel,
then the unit sounds SIREN tone.
“ALERT”
and the
“Weather
channel”
blink on the display. The unit cancel
CB
or
PA
mode and go to
WEATHER
mode.
During a SIREN tone sound, press any key to stop the sound,
“ALERT”
and the
“Weather
channel”
stop blinking on the
display.
Note:
The SIREN tone sounds when
ALERT
is detected in the
selected
WEATHER channel only. Use first
SCAN
function in
WEATHER
mode to detect tones
in
all
the WEATHER channels
(see §
WEATHER MODE
above)
.
M1
See §
MEMORY
page 12
.
9) NB/ANL/HIC ~ SCAN ~ M2
NB/ANL/HIC
(short press)
NB ANL
: Noise Blanker / Automatic Noise Limiter. These filters
allow reducing back ground noises and some reception
interferences.
HI-CUT:
cuts out the high frequency interferences.
Short press
NB/ANL/HIC
(
9
) key to alternate the different
status :
Filter icon appears on the display when status in
on
.
SCAN
(long press)
CB
MODE
Press and hold
SCAN
key (
9
) for 1 second to activate
SCAN
function (for
CB channels
) in an increasing way.
“SCAN”
is displayed. The scanning stops as soon as there is a busy
channel. The scanning automatically starts 3 seconds
after the end of the transmission and no key is activated
during 3 s. The scanning starts again in an increasing way
by turning to the right the
CH
rotary knob or pressing the
UP
key (
6
) on the microphone, or in a decreasing way, by
turning to the left the
CH
rotary knob or pressing the
DN
key (
6
) on the microphone.
While scanning, press •
F/MEM
key (
11
) to alternate between
All Channel Scan
and
Memory Channel Scan
.
In
Memory Scan Channel
mode, channel 9, channel 19
and the memorised channels are scanned.
English
