MINI ONE XL - MANUAL
10
www.preservatech.com
Please contact [email protected] if you require assistance.
OVERFLOW PORT
As the unit removes moisture from the air, the water vapor condensed will be deposited in
the treatment tank reservoir. Humidity that is removed from the vitrine when the Mini One XL is in
dehumidifying mode may drip from the unit at the overflow port.
You may connect the overflow port to the drain, collect condensate in a container, or simply allow it
to evaporate from a shallow tray.
When a automatic filling system is in use, connection to drain is necessary.
OPERATION MANUAL
AUTOMATIC FILLING SYSTEM
If automatic filling system is in use, just open the shut off valve on water feed pipe. Machine will
draw water automatically after starting. Please note that a empty machine can takes up to 2 hours to
start.
Please refer to “Water and drain” chapter for more information.
WATER RESERVOIR
Before filling the water reservoir, it must be connected to a power
outlet and the machine must be turned ON. When filling the machine
keep an eye on the water level indicator on the controller until it
displays “Water Full”
Distilled water must be used
Please refer to ”Water reservoir” chapter in Installation chapter.
STARTING MACHINE
Before starting please check if the installation is done correctly:
-
Power cable is connected to the proper outlet. (link)
-
Water and drain are properly connected. (link)
-
Air Pump(s) are connected. (link)
-
Air hoses are properly connected to the machine and cases. (link)
-
RHT sensor is installed. (link)
Machine can be turned ON. Please note it take up to 2 hours on empty machine to fully start
operation.
-