CONGLOMKB .COM
Please contact
or
1-877-333-0098
for further assistance .
ENGLISH
11
Installation (continued)
INSTALLING THE FAUCET
-
Connect the sprayer head (1) to the sprayer head
connector (2).
-
Remove the gasket (3), metal washer (4), and
retaining nut (5) from the mounting shank of
the faucet .
- Insert the faucet hose and the mounting shank
through the faucet hole in the sink and rest the
faucet on the sink .
- From underneath, secure the faucet to the
sink with the gasket (3), metal washer (4), and
retaining nut (5).
-
Tighten the retaining nut (5) by hand until it is
snug . Use a wrench to tighten it down . Gently
tighten the two screws on the retaining nut . Do not
overtighten .
-
Connect the main water supply outlet (6) to the
sprayer hose (9) using the quick connector (7) as
shown. Connect the male quick connector fitting
(8) to the female quick connector fitting (7) until it
locks. Lightly tug on the quick connect fittings to
ensure they are fully engaged .
-
Fully retract the sprayer hose (9). Install the
counterweight (10) about 2 in. (50 mm) from the
bottom on the side closest to the sprayer head (1).
There should be no slack in the hose and it should
retract freely .
-
Attach and hand tighten the supply lines (not
supplied) onto the faucet inlet fittings. Use two
wrenches to tighten the two ends together .
NOTE: Failing to use two wrenches can damage the
faucet and void the warranty. Do not overtighten. It is
helpful to have a second person hold the faucet in place
while tightening the mounting nuts. Please ensure that
none of the supply lines are kinked during installation.
QUICK CONNECTOR
Female Quick
Connector
Fitting (7)
Male Quick Connector
Fitting (8)
Spring
Sprayer Head
Connector (2)
Sprayer
Head (1)
Faucet body
Gasket (3)
Retaining
Nut (5)
Metal
Washer (4)
Mounting
Shank
Screws
Counterweight (10)
Hot / Cold
Supply Lines
Supply Line
Inlet Fittings
Sprayer Hose (9)
Male Quick
Connector Fitting (8)
Female Quick
Connector Fitting (7)
Main Water
Supply Outlet (6)
Supply Line
Inlet Fittings
1/2" NPS thread
1/2" FIP
Water Supply
Line Compatible
Fig . 9
Fig . 10
