3. 1 Product disassembly precautions and steps
：
3.UNPACKING WAYS OF MAIN PARTS
1>
General attention
：
1.
When you remove or repair, please you must unplug the power cord firstly
2.
When you connect wire
，
you
are sure to connect wire with wiring cap
，
use the tool to
press wiring cap for connecting firmly and use tape to make the line insulation fully.
3.
When you plug wire and connect wires, you must insert terminals to the roots for not easily
pulling.
4.
When you decorate internal wires
，
you fix internal wires to avoid encountering moving
parts for example v-belt, pulley
，
suspend pole, etc or high temperature parts according to
original state.
5.
The removing screws must be preserved goodly
，
because you need screws to install.
6.
When you diagnose faults, you are very careful to not get an electric shock if you need to
operate
in electricity situation.
2> Product disassembly steps
：
1.
Remove the screws on the rear cover
，
remove the drain hose screws and then take down
the rear cover.
2. Remove the earth screws, capacitor screws, and then pull out the air pipe.
3. Pull the insulating bag and then remove the wire connector.
4.
Pull out the front control panel screws, and then remove the top cover screws.
5. Take down the top cover subassembly, and put it in the right place
6. Remove the controller board screws,
pull out the controller board terminals
，
and then
take down the controller board and the front control panel.
7. Take down the back control panel, cover switch, nozzle
，
water level sensor
，
and
internal wire subassembly .
8. Take down cover pin, twist spring and take out cover subassembly..
9. Remove the outer tub cover screws and the impeller screws, finally take out the outer tub
cover and the impeller.
10.Take out impeller adjusting washer
，
remove the big nut and take out the coupling flange
washer.
11. Take out spin tub subassembly.
12. Take out the outer tub subassembly.
13. Turn the outer tub subordinate-subassembly, and remove the motor screws
，
the bracket
screws
，
the clutch body subassembly screws
，
the retractor screws
，
and the drain
pump screws
（
or drain valve subassembly screws
），
finally take out motor
，
bracket
，
clutch body subassembly
，
retractor
，
and drain pump
（
or drain valve subassembly
）
.
14. Remove the base plate screws, and then take out outer tub subordinate-subassembly on
the base plate
15.
In turn counterclockwise (or clockwise) order take out the suspend poles, and then put
them down on the ground.
16. Remove the power cord.
17. Remove the base subassembly for cabinet screws
，
and then take out the base
subassembly for cabinet.
15
