Premium 0503ABWVAG70P, Operating Instructions Manual

Page: 13 / 61

Проверил: Р.Ч./07.2015г
11
area before use.
Figure 7- Detergent application
Units with Detergent Applicator
Included
Follow manufacturer’s label directions for
mixing correct concentrations of detergent
to water ratio through the pressure washer
is approximately 5.4% (1 to 19).
1. Unscrew to top of detergent applicator
and fill applicator with detergent.
2. Replace top on applicator.
3. Remove lance from gun.
4. Attach detergent applicator to gun. ( See
Figure 8)
5. Apply detergent so it thoroughly covers
cleaning surface. Apply from bottom to top
to prevent detergent from sliding down and
streaking.
6. Allow detergent to remain on the surface
for a few minutes. This is a good time to use
a brush to lightly scrub heavily soiled areas.
Never allow detergent to dry on the
cleaning surface.
7. Remove detergent applicator from gun
and replace with the lance, or remove
applicator from end of lance.
8. Rinse detergent from surface.
NOTE:
Flush detergent applicator with
clear water following each use.
4. Final Rinse
Start final rinse at bottom an work upward.
Make sure you thoroughly rinse the surface
and that all detergent has been removed.
5. Shut down
1. Be sure all detergent is flushed from
system.
2. Turn off motor.
3. Turn off water supply.
4. After motor and water supply are turned
off, trigger gun to depressurize system.