Premium Leisure Dual Zone 18, Owner'S Manual

Page: 31 / 63

DANGER: If this breaker does not trip, immediately call your electrician.
Do not use your swim spa!
Only if pushing this button successfully trips this circuit breaker should you
reset this breaker and proceed to the next step.
2. Go to the topside control panel. The spa side of the unit first goes into a
6-minute Priming mode, indicated by “Pr” message. Water heating is
disabled during priming. To exit Priming mode and begin normal swim
spa operation, press “WARM” (or the up arrow) or “COOL” (or the down
arrow).
3. Press the “JETS” button. You should hear pump 1 turn on, see water
circulating, and see the Jets light illuminate on the panel.
4. Press the JETS button again. You should hear the pump turn on a
higher speed.
Caution: If water is not flowing from the jets after 2 minutes, turn the
power off at the main panel and bleed air from the system (see
page 43-44). Turn the power on again. Sometimes momentarily
turning the pump off/on will help to prime. Do this only 4 times.
5. If the water is running smoothly through the lines, open the air control
valve to the jets and you should see an increase in jet pressure. Check
and adjust the water and airflow of every jet if necessary.
Each hydrotherapy jet in the spa side can be adjusted for massage intensity
and directional flow. Turn the outer jet dial counterclockwise to increase the
water volume and clockwise to turn it off. Pivot the angle of a jet to achieve
an optimal massage.
An air mixture intensifies the level of your massage. Turn the air control
valve counterclockwise to increase the air mixture and clockwise to turn it
off.
To minimize heat loss, close the air control valve when the swim spa is not
in use.
6. Press the JETS button a third time to turn off pump 1.
Note : The pump remains on if filtration or heat is needed.
7. Press the LIGHT button to turn on all lights. Verify that the LED light
system is on. Press the LIGHT button multiple times to cycle through
the many available color patterns. Press the LIGHT button again to turn
off the LED light system.
Page 29
For HELP, call 727.573.9611