Premium Leisure Dual Zone 18, Owner'S Manual

Page: 26 / 63

Before Adding Water
Before adding water, go through these simple steps now to prevent common
issues when setting up your
swim spa for the first time. Verify that the following
have all been rechecked.
1. Turn off all power to the swim spa at the main breaker panel.
2. Open the side panels to access the internal components.
3. Check that all slide valves are opened (T-
handles pulled out) to the heater and all
pumps.
4. Check that there are no obvious signs of
loose wires or broken pipes.
Figure 18 - Valve Open/Closed
5. Check that the two heater unions are
hand tight.
Caution: Do not use a wrench. Over-
tightening may cause damage
to unions and gaskets, which
will not be covered under
warranty.
Figure 19 - Unions Tight
6. Check that the unions on all pumps are tight.
7. Clean out any foreign debris from within the service access area or inside of
the swim spa itself.
8. With the drain open and filters removed, thoroughly rinse out the swim spa
with warm water until the drained water runs clear. Run water through the
filtration canister and jet lines to remove any incidental dust, dirt, and debris
that may have accumulated during shipment or installation. Drain all water
completely.
9. Make sure that the swim spa drain valve is closed and the cap is on tight
(see page 49).
10. Install the filter(s) in the filtration canister.
11. Check that all of the
swim spa jets are open (turned full counter-clockwise).
12. Now is the best time to clean and polish the surfaces of your swim spa (see
page 44).
Page 24
For HELP, call 727.573.9611