P-5
Pull the head off
The rotating head has four
primary cutting positions
Rechargeable Battery
Before first time use, the hair trimmer must be fully charged.
1. Slide the On/Off switch downwards.
2. Insert the plug of the mains adaptor into the power jack of the hair clipper.
3. Plug the mains adaptor into a power socket outlet.
Ni-cad battery life may be extended with the following procedure: once every month, let the clipper run
until the motor stops. Move the switch to the “OFF-0” position and recharge fully overnight.
Guide comb
Use the guide comb to shorten hair evenly. To set the desired length, insert the edge of the comb
attachment into the swivel head. Make sure the comb attachment locks into position properly.
Clean & Maintain
1.
Switch off the appliance and disconnect it from the mains.
2.
Remove the comb attachment.
3.
Clean any loose hair that has collected in the blades and comb attachment.
Oiling
Oil the shaving head from time to time if you use the trimmer regularly. Use non-corroding oil, for
example sewing machine oil.
1. Remove the comb attachment used.
2. Apply one to two drops of oil between the cutting teeth.
3. Turn the trimmer briefly on and then off again to distribute the oil.
4. Remove any excess oil by wiping with a cloth.
STORAGE
-Ensure the appliance is completely cool and dry.
-Do not wrap the cord around the appliance, as this will cause damage.
-Keep the appliance in a cool, dry place.
The characteristics can change without preliminary preventing
For additional protection, the installation of a residual current device with a rated residual operating
current not exceeding 300 mA is advisable in the electrical circuit supplying the bathroom. Ask your
installer for advice.
Accessories
Summary of Contents for ED-5185
Page 8: ......
