PREMIER COLLECTIONS
assembly instructions
Step 1
:
Unroll kite and lay out flat facedown. Make sure Bridle Lines stay in front of kite (beneath kite as it's laid out on the ground)
and Tensioning Lines stay in back (on top) of kite as each section of kite body is unrolled.
Step 2
:
Assemble each of the pre-inserted Horizontal Rods by connecting rod segments inside sleeves at ferrules. (Note: the top
Horizontal Rod has three segments to connect while the rest have two) Hook black Bungee Cords attached to sleeve
openings to Arrow Nocks on ends of all Horizontal Rods. (diagram A)
Step 3
:
Assemble 3-piece Spine Rod and slide capped end (end without Arrow Nock) up through sleeve at bottom point of kite
body. Continue to slide Spine Rod up along center of kite body through Plastic Rings attached to tops of Horizontal Rod
Sleeves. Insert capped end of Spine Rod into pocket at top point of kite body. (diagram B)
A
connect Horizontal Rod
segments inside sleeves
note: top Horizontal
Rod has three segments,
all others have two
Bungee Cord
Bungee Cord
Arrow Nock
Arrow Nock
Bungee Cord
Arrow Nock
Bungee Cord
Arrow Nock
B
connect Spine
Rod segments
capped end of
Spine Rod goes
into pocket at
top of kite body
connect Spine
Rod segments
Spine Rod should
pass through all
Plastic Rings along
center of kite body
slide Spine Rod
through sleeve at
bottom of kite body
