premierpet.com
What’s Included
Fit the Collar
Important: The proper fit and placement of your Bark Collar is important for effective operation.
1. Start with the collar turned off and your dog standing comfortably,
not sitting.
2. Remove all other collars your dog may be wearing and place the
bark collar around his neck. Place the collar on your pet so that the
Premier Pet
™
logo is right side up and the collar is directly under your
dog’s chin. Center the contact points underneath your dog’s neck,
touching the skin.
NOTE: It is sometimes necessary to trim the hair
around the contact points to make sure that contact is consistent.
3. Check the tightness of the collar by inserting one finger between the
end of a contact point and your dog’s neck. The fit should be snug but
not constricting.
4. Allow your dog to wear the collar for several minutes, then recheck the fit. Check the fit again as your
dog becomes more comfortable with the collar.
Do not shave the pet’s neck as this may increase the risk of skin irritation. The collar should not be worn for more
than 12 hours out of every 24-hour period. Leaving the collar on too long could lead to skin irritation.
To Insert and Remove the Batteries
1. Turn the battery door counter-clockwise using a coin.
2. Install two (2), 3-volt batteries positive (+) side out, negative (-)
side pointed toward inside of battery unit. Place the lower 3-volt
battery under the positive battery contact. Insert the upper 3-volt
battery against the positive battery contact.
3. Replace the battery door using a coin as shown. Turn the battery
door clockwise.
4. Replacement batteries (3-volt batteries, GAC11-16388) can be
found at many retailers. Contact the Customer Care Center or visit
our website to locate a retailer near you.
There is a risk of explosion if a battery is replaced by an incorrect type. Do not short circuit, mix old and new
batteries, dispose of in fire or expose to water. When batteries are stored or disposed, they must be protected
from shorting. Dispose of used batteries properly.
Contact Points
Washers
Sensor Probe
Low Battery
Indicator Light
Bark Collar
3V Lithium Coin Cell Batteries
(GAC11-16388)
