9532-002-001-11
PSD-TTS-B
Installation Guide
10
Securing the flat panel to the stand
Step 4
Raise the display
(see warning on this page)
and slide the mounting brackets over the tubes, set the height required and using the Allen
wrench secure the height by tightening the four (4) M8 socket head screws.
Do not over tighten the screws.
Make all proper connections
at this time. Install the back cover plate and secure it using two (2) M5 x 10 phillips screws (supplied).
See figure 4.
Allen wrench
Back cover
(2) M5 x 10
phillips screws
WARNING: AT LEAST (2) QUALIFIED
PERSONNEL ARE STRONGLY
RECOMMENDED FOR INSTALLATION OF
THIS PRODUCT. FAILURE TO DO SO
COULD RESULT IN SERIOUS INJURY AND
POSSIBLE DAMAGE TO THE FLAT PANEL.
Cable routing access
points
