www.mounts.com | North America 800.368.9700 | Interna1-714-632-7100
Installation Guide
GB-AVSTOR3
8
9
Attaching Equipment to the Tray
Attaching the Mounting Tray to the GB-AVSTOR3
1) Place your electronic components onto the mounting tray.
2) Align the electronic components so that the weight is distributed as
evenly as possible.
3) Run the zip ties through the mounting slots on the tray, underneath
the mounting tray and up though the mounting slot on the other side
of the electronic component.
4) Tighten the zip tie down and cut off any excess zip tie.
1) Insert four (4) M5 x 8mm Phillips head screws loosely into the outer holes
inside the GB-AVSTOR3 (Figure 1).
2) Place the mounting tray into the middle section of the GB-AVSTOR3 (Figure 2).
3) Hook the mounting tray onto the heads of the M5 x 8mm Phillips head screws on the
GB-AVSTOR3 (Figure 3).
4) Insert two (2) M5 x 8mm Phillips head screws into the middle mounting holes of the
mounting tray.
5) Use a Phillips tip screwdriver to tighten all six (6) screws.
As a reminder, small screws and flat washers may also be used to
attach electronic components to the grid.
Do not over tighten the mounting screws.
Zip Tie
Mounting Tray
Figure 1
M5 x 8mm Phillips head
Screw
Figure 2
Figure 3
Page 7
