www.mounts.com | North America 800.368.9700 | Interna1-714-632-7100
Installation Guide
GB-AVSTOR3
7
Ceiling
Framework
24” T-Bar Frame
24” x 48” Ceiling Tile
Opening
The replacement 2’ x 2’
ceiling tile goes here.
Figure 3
Figure 4
Figure 2
Figure 1
Quick Lock
6” Excess 1/16”
Braided Cable
1/16” Braided Cable To
Ceiling Attachment
Ceiling Framework
It is recommended that the following steps be performed by two people.
When adjusting the tension of the weight-bearing side of the Quick Lock,
the 1/16” braided cable must be pulled through the Quick Lock until the
desired tension is attained.
Once the tension has been adjusted, be sure that there a minimum of
6” of excess 1/16” braided cable on the non-weight bearing side of the
Quick Lock (Figure 2).
1) Lift the ceiling box from the exposed ceiling framework until the
ceiling box’s outer lip rests against the bottom of the ceiling
framework (Figure 1).
2) Adjust the 1/16” braided cable tension, but do not over tighten.
4) Use cable cutters to remove any remaining 1/16” braided cable (optional).
If you installing the GB-AVSTOR3 through a 24” x 48” ceiling tile opening,
attach a 24” T-bar frame ( commercially available) in the 24” x 48” ceiling tile
frame for support and place a 2’ x 2’ ceiling tile adjacent to the GB-AVSTOR3
(Figures 3 and 4).
3) When you have the desired tension, pull the 1/16” braided cable through
the other side of the Quick Lock.
Page 6
