www.mounts.com | North America 800.368.9700 | Interna1-714-632-7100
Installation Guide
GB-AVSTOR3
3
4
Ceiling Box Installation
Ceiling Attachment
Wood Stud Ceiling
Concrete Ceiling
Ceiling Tile
1) Determine the placement of the GB-AVSTOR3.
2) Remove the ceiling tile where the ceiling box will be mounted.
The ceiling box must be secured using the Quick Locks and 1/16” braided cables (supplied).
1) Determine the mounting location.
2) Use a 1/8” drill bit to pre-drill the mounting holes.
3) Secure the four (4) 1/4” eye lag screws to the wood stud in the ceiling.
4) Run the open end of the 1/16” braided cable through the hole
in an eye lag screw.
5) Run the open end through the loop.
6) Pull the open end down until the 1/16” braided cable tightens
around the eye lag screw.
7) Repeat steps 4-6 for the remaining three mounting points.
1) Determine the mounting location.
2) Use a 1/4” concrete drill bit to drill the mounting holes.
3) Place the concrete eye anchor bolts into the pre-drilled holes
and gently tap into place using a rubber mallet or hammer.
4) Run the open end and 1/16” braided cable through the hole in
an eye anchor bolt.
5) Run the open end through the loop.
6) Pull the open end down until the braided cable tightens around
the eye anchor bolt
7) Repeat steps 4-6 for the remaining three mounting points.
Store the ceiling tile in a safe location in the event that it needs to
be reused.
Eye Anchor Bolt
Eye Lag Bolt
Page 4
