ECM-3763D
Installation Instructions
Page 7
Inserting the Hex Head Bolts
Align the hex head with the keyhole slot.
Gently insert the hex head through the keyhole
slot and lower the elliptical tilt mount.
Align the lower mounting holes of the dual
mounting bracket with the lower mounting points
on the elliptical tilt mount.
Thread two (2) M6 x 12mm hex head bolts two (2)
M6
split
fl
at washers into the mounting holes.
Use a 10mm wrench and tighten all four (4)
M6 x 12mm hex head bolts.
Repeat steps 1 through 5 for mounting the second
elliptical tilt mount.
Do not completely tighten the hex head bolts at
this time.
Mounting
Surface
¼
˝
Gap
Hex Head
M6 x 12mm
Hex Bolt
Upper
Mounting Hole
Elliptical Tilt
Mount
Attaching the Elliptical Tilt Mount to the Dual Mounting Bracket
Keyhole Slot
The following steps must be completed by two
people.
Locate the two (2) upper mounting holes located
on the back of the elliptical tilt mount.
Attach two (2) M6 x 12mm hex head bolts and two
(2) M6 split
fl
at washers.
Thread the hex bolts into the hole until there is a
¼
˝
gap between the head of the hex head bolt and
the mounting surface of the elliptical tilt mount.
Repeat steps 1 through 3 for the second elliptical
tilt
mount.
Do not release the elliptical tilt mount until the hex
head bolts are resting fully in the keyhole slots.
Keyhole Slot
10mm Wrench
10mm Wrench
M6 x 12mm
Hex Head Bolt
M6 x 12mm
Hex Head Bolt
Lower
Mounting Holes
Lower Mounting
Points
Proceed to
“Selecting the Mounting Hardware”
section.
Proceed to
“Attaching the Elliptical Tilt Mount to
the Dual Mounting Bracket”
section.
M6 x 12mm
Hex Bolt
M6 x 12mm
Hex Bolt
M6 Lock
Split Washer
