RECEIVER INSTALLATION/SERVO CONNECTIONS
DEFAULT AURA CONNECTIONS
S1
S2
S3
S4
S5
S6
S7
S8
Throttle (ESC/BEC)
Left Aileron
Right Aileron
Elevator
Rudder
(Empty)
LED Controller
(Empty)
Aura will auto-detect modern digital receiver connection(s). Using a
modern digital receiver connection gives the Aura access to
precise data of each channel for additional gyro-enabled outputs,
simplifies wiring, and allows for more advanced features. To
connect a modern digital receiver connection, follow the steps on
pages 10 or 11 (depending on your receiver type), then skip ahead
to page 13.
For traditional PWM receivers without digital connection(s), male to
male servo leads must be used for each channel. Please refer to
the connection diagram on page 12.
Supported Modern Data-Linked Receivers
Connecting Your Receiver to Aura
1.
2.
3.
4.
5.
Connect one Spektrum Remote Receiver to Mini Port 'A' at the
top of the Aura case. If using two, connect the second to Mini
Port 'B'.
To bind a DSMX Spektrum Remote Receiver connection, insert
a bind plug into Aura Port S8.
Port 'B' is NOT for binding.
To bind a DSM2 Spektrum Remote Receiver connection, insert
a bind plug into Aura port S1 AND S8.
Connect the flight battery to the ESC, and the remote receivers
should begin to flash, indicating that they are ready to bind.
Bind from here as recommended by your transmitter
manufacturer.
Confirm the remote receiver(s) is(are) bound by verifying a solid
LED on the receiver.
Aura will then automatically begin the Auto-Detect process,
indicated by sweeping LEDs on the Aura. Once found, you will
see a solid orange (power and calibrated sensor) and solid
green (valid receiver data) LED on the Aura indicating the Aura
is in its flight-ready state.
Mount your receivers using double sided foam tape, or hook
and loop tape. Consult your receiver manual for proper
mounting orientations and procedures.
Aura will auto-detect these modern digital receiver connections:
Spektrum Remote Receiver(s)
Futaba or Hitec S.Bus
Graupner HOTT (Sum D of 8)
Spektrum SRXL
JR XBus (Mode B)
Jeti UDI12 (standard)*
A PPM (8CH, negative shift, approximately 22ms/frame) receiver may also be
connected into Port 'B', however Aura will not auto-detect and setup must be
performed through the Aura Config Tool (Windows Application).
Spektrum Remote Receivers
If you are unsure which type of DSM remote receiver you
have, start by attempting the bind process with a bind plug
in S8. If you continue to have trouble binding, then insert
one bind plug in S1, and one bind plug in S8.
If you are using a traditional Spektrum receiver, with
either a digital connection type or with PWM
connections, DO NOT plug any remote receivers into the
Aura 8. They should instead be plugged directly into
your traditional receiver.
10
Note: It may be necessary to move the ESC lead to another open
port (such as 'Port B') during the binding precedure. Be sure to
return the ESC lead back to S1 after binding is complete.
Note: There are many JR-branded remote receivers that use
Spektrum DSM2 and DSMX RF protocol. For these, follow
the instructions for Spektrum remote receivers.
For specific information on receiver types and our
recommended receivers for this aircraft, please visit the
QQ Extra 300G2 Wiki page at the below URL:
wiki.flexinnovations.com/wiki/QQExtra300G2
Summary of Contents for QQ EXTRA 300G2
Page 1: ...Day Night Versions Day Night Versions G2 G2 ...
Page 2: ......
