28
3.
Check the condition of the slot.
If it is badly worn, change wheel.
4.
Check threads in Insert and on Bolt.
If damaged, replace. If re-using, make
sure they are clean and free from dirt.
The bolt can be re-used up to five
times before it needs replacing,
providing it isn’t damaged.
Only use bolts supplied by Multi-Tip.
6.
Make sure all surfaces are clean and
free from dirt. Re-fit the threaded insert,
then the new tooth and keeper block together.
Tap the front of the keeper block until it is
located. Insert the bolt and wind up to a
torque setting of 55Nm (40 ft-lb)
After ten minutes of use stop and check
bolt tightness.
If the assembly can not be tightened
sufficiently into the wheel, do not use.
Never use this system without all
components in place and secure.
5.
Check condition of keeper plate.
If badly worn or damaged, replace.
Replace tooth with new.
