Page 10
For technical questions, please call 1-888-866-5797.
ITEM 63022
SAFETY
SETU
p
Op
ERA
TION
M
AINTENANCE
Starting the Engine
Before Starting the Engine
Before starting the engine:
a.
Follow the pre-start Checks to prepare the Auger.
b.
Inspect the Auger and engine.
c.
Fill the engine with the proper amount and type of unleaded gasoline and 2-cycle oil mixture.
d.
Check the work area for utility lines and landscaping fabric.
Do not use near utility lines, and cut landscaping fabric clear before drilling.
e.
Read the section that follows.
1. Place the Auger on its side with its Bit resting
on the ground that is to be drilled.
WARNING! Make sure that no debris, clothing,
or other objects are near the Bit.
Keep all bystanders away.
2. Press the Primer
three or four
times. See Figure B.
primer
Figure B
3. Set the Choke (see Figure C):
START
if the Engine is cold.
RUN
if the Engine is warm.
Choke
START
RUN
power Switch
Starter Handle
Figure C
4. Move the Power Switch to the I position.
Squeeze and release the Throttle.
5. Grip the Frame firmly with your left hand. Keep
all body parts well away from the Bit. Then,
with your right hand, grip the Starter Handle
of the Engine gently until resistance is felt.
Allow Cable to retract fully and then pull it
quickly. Repeat until the engine starts.
Note:
Do not let the Starter Handle snap back against
the engine.
Hold it as it recoils so it doesn’t hit the engine.
