Page 5
For technical questions, please call 1-888-866-5797.
ITEM 59206
Sa
FE
ty
SE
tup
Op
Era
ti
O
n
Maint
Enanc
E
38. Do not operate the Generator with known
leaks in the engine’s fuel system.
39. When spills of fuel or oil occur, they must be
cleaned up immediately. Dispose of fluids and
cleaning materials as per any local, state, or
federal codes and regulations. Store oil rags in
a bottom-ventilated, covered, metal container.
40. Keep hands and feet away from moving parts. Do
not reach over or across Generator while operating.
41. Before use, check for misalignment or binding
of moving parts, breakage of parts, and any
other condition that may affect the Generator’s
operation.
if damaged, have the Generator
serviced before using.
Many accidents are
caused by poorly maintained equipment.
42. Use the correct generator for the application.
Do not modify the generator or its engine,
and do not use the generator for a
purpose for which it is not intended.
43. Extension Cord - Make sure your extension cord
is in good condition. When using an extension
cord, be sure to use one heavy enough to carry
the current your product will draw. An undersized
extension cord will cause a drop in line voltage
resulting in loss of power and overheating.
The following table shows the correct
cord size to use depending on cord length
and nameplate ampere rating. If in doubt,
use the next heavier gauge. The smaller the
gauge number, the heavier the cord.
rEcOMMEnDED MiniMuM WirE GauGE FOr EXtEnSiOn cOrDS
currEnt
(aMpS)
Load @
120V
(WattS)
Load @
240V
(WattS)
0 ~ 50 ft
50 ~ 75 ft
75 ~ 100 ft
2
240
480
18 AWG
4
480
960
18 AWG
16 AWG
6
720
1440
18 AWG
16 AWG
14 AWG
8
960
1920
16 AWG
12 AWG
10
1200
2400
16 AWG
14 AWG
12 AWG
15
1800
3600
14 AWG
12 AWG
10 AWG
20
2400
4800
12 AWG
10 AWG
25
3000
6000
12 AWG
10 AWG
8 AWG
30
3600
7200
10 AWG
8 AWG
35
4200
8400
8 AWG
6 AWG
40
4800
9600
6 AWG
