Solana Assembly and Maintenance Guide
page 31
1
2
3
4
5
6
Step 2. Selector Stem Adjustments
Forward Angle
Selector Stem
Top Cap
Weight
1 ½" Socket
Cap Bolt
U Bracket
Allen head
set screw
Inside
surface
Set screw
▲
B
B
A
2. Selector Stem Adjustments
To prevent the Selector Stem from contacting the inside
of the Weight Stack when the machine is in use, you
need to check the vertical angle of the Selector Stem
(steps A and B). If the stem slides smoothly without
contacting the inside of the weight plates, assembly of
the unit is complete.
CAUTION: Performing the following tasks requires
two people.
A. Remove the Weight Pin from the Weight Stack.
B. Perform an exercise using each part of the Solana.
When the base of the Selector Stem is clear of the
Weight Stack, observe the position
of the Selector Stem.
The following sections describe how to adjust the
Selector Stem when contact does occur.
The Selector Stem can be adjusted forward, backward,
and vertically depending on the area of contact.
Forward Angle Adjustment
When the Selector Stem angles forward (toward the
seat) and contacts the inside of the Weight Stack
during use, adjust it by following these steps:
CAUTION: This adjustment requires two people.
A. Completely disassemble the Top Cap Weight,
Selector Stem, and U bracket.
B. Thread the Allen head set screw into the hole
closest to the top of the U bracket and turn it
clockwise until the end of the screw is flush with
the inside surface of the U bracket.
C. Turn the set screw clockwise another one-half turn
(see diagram).
