Procedure 7.12 - Replacing a Speed Sensor Assembly
Procedure
1.
Set the on/off switch in the “off” position, then unplug the power cord from the wall outlet.
WARNING
Before continuing with this procedure, review the Warning and Caution statements listed in
Section One, Things You Should Know.
2.
Remove the right hand cover section as described in Procedure 7.1.
3.
Remove the snap on cover from the lower PCA.
4.
Disconnect the speed sensor cable from the J7 connector on the lower PCA. See Diagram
6.3.
5.
Unsnap the speed sensor from the speed sensor bracket and remove the speed sensor.
See Diagram 7.7.
Diagram 7.7- Speed Sensor
6.
Snap the replacement speed sensor into the speed sensor bracket. See Diagram 7.7.
7.
Reconnect the speed sensor cable to the J7 connector on the lower PCA.
8.
Replace the snap on cover on the lower PCA.
9.
Re-install the right cover section as described in Procedure 7.1.
10. Check the operation of the EFX as described in Section Four.
Speed Sensor
Bracket
Speed Sensor
Summary of Contents for EFX EFX 5.23
Page 79: ...Block Diagram 8 2 5 23 5 25...
