Cardio Theater DVD Integrated Bracket Assembly Instructions
page 5
Install the DVD Player into the DVD Integrated Bracket Assembly
3
VIDEO
DOLBY
DIGITAL
COAXIAL
R-AUDIO-L
S-VIDEO
PHONE REMOTE
DC 12V
1.
Remove the two front and back screws on
each side of the DVD Player, leaving the
middle screw. Discard these screws; you will
not need them later.
2.
Connect the audio/video cable and the power
cable to the back of the DVD Player.
Note:
For more information about cable
connections, see the manual that was pack-
aged with the DVD Player.
3.
Slide the DVD Player into the bottom bracket.
4.
Feed the cables through the upright portion of
the bracket.
5.
Place the top bracket over the DVD Player and
bottom bracket.
Make sure that the upright portion of both top
and bottom brackets match, and that you do
not pinch any cables between the two brackets.
6.
Secure the top bracket to the bottom bracket
with four Phillips-head screws and washers,
provided in the box.
Insert two Phillips-head screws and washers
on each side, leaving the middle hole empty.
You may need to adjust the top cover a bit to
align the holes and insert the screws. Tighten
the screws.
Important:
Be careful not to overtighten the
screws and strip them.
Install the DVD
Player into the
DVD Integrated
Bracket Assembly
Power
cable
Audio/video
cable
1
3
Bottom
bracket
Feed cables
through upright.
Slide DVD Player
into bottom
bracket.
DVD
Player
4
Top bracket
Make sure that the cables are not
pinched between the upright
brackets.
5
Insert two Phillips-head
screws and washers on
each side of the bracket.
6
