Preco PreView WD7102, Operating Manual

Page: 18 / 24

+1.866.977.7326 www.preco.com 3700076F
Copyright 2016
Page 12
Connection to Sensor Failed Screen:
If installation method “A” (display wired to ignition and reverse) was used
and the sensor does not communicate with the display when the machine is
placed into reverse, the home screen will show a “Connection to Sensor
Failed” (Figure 3.4) error. If installation method “B” (display wired only to
ignition) was used and the sensor does not communicate with the display,
the display will continue to show the “Not In Reverse” message (Figure 2.2)
as it relies on the sensor to tell the display when reverse has been activated.
In either case, if the machine is placed into reverse and the system does not
become active see the Troubleshooting portion of this manual.
Home Screen, Connection to Sensor Failed! (Figure 3.4)
Sensor BIST Failure Screen:
If this screen appears, please contact PRECO Electronics
®
for assistance.
Home Screen, Sensor BIST Failure (Figure 3.5)