6
PM 25MV v9 2020-10
Copyright © 2020 Quality Machine Tools, LLC
PM25MV-BD SPECIFICATIONS
T-slot dimensions
Dimensions
Approximate weight:
Machine only
275 lb net, 320 lb shipping
Welded steel stand
50 lb net, 54 lb shipping
Size, including stand
W 39 in. x D 20-1/2 in. x H 68-1/2 in.
Stand footprint
W 13-1/2 in. x D 16-1/2 in.
Tray
W 19-3/4 in. x D 20-1/2 in.
Electrical
Power requirement
120V, 60 Hz, single phase
Spindle motor
Brushless dc, 750W (1 HP)
Full load current
14A
Headstock
Vertical travel*
13 in.
Left-right tilt
90 degrees clockwise/counter-clockwise
Spindle
Speeds (rpm)
Low range 50 to 1250, High range 100 to 2500
Internal taper
R8
Quill travel
2 in.
Quill diameter
2.36 in.
Spindle nose to table
2 in. min, 12 in. max
Spindle centerline to front face of column
6 in. to pleated cover (uncovered, 7 in.)
Drawbar
Standard 7/16 - 20 thread
Table
Size
W 27-1/2 in. x D 7-1/8 in.
Surface height over mounting surface
Approx 7 in.
Surface height over floor, if on stand
Approx 38-1/2 in.
Maximum load
200 lb, table centered, less if overhanging
Leadscrews
Acme, inch pitch, 10 tpi
Left-right travel (X-axis)*
20-1/2 in.
Front-back travel (Y-axis)*
7 in.
T-slots (3)
12 mm wide, 63 mm (2-1/2 in.) centerlines
* DRO installation may limit these numbers
