PRECISION DIGITAL PD2-6210, Instruction Manual

Page: 29 / 60

PD2-6210 Helios Large Display Analog Input Batch Controller Instruction Manual
29
Display Parameter Action/Setting Description
G total
Grand total Assign relay to grand total
m bus
Modbus
Select to display Modbus input or to assign Modbus input as the
analog output source
rate
Rate
Assign relay to rate
precls
Batch total relay
preclose
For relays beyond the first assigned to total, a preclose amount may
be entered.
RLY 1
Relay 1 Relay 1 setup
Act 1
Action 1 Set relay 1 action
Auto
Automatic
Set relay for automatic reset
A-nman
Auto-manual
3
Set relay for automatic & manual reset any time
LatCH
Latching 1
Set relay for latching operation
Lt-CLr
Latching-cleared 1
Set relay for latching operation with manual reset only after alarm
condition has cleared
Altern
Alternate
4
Set relay for pump alternation control
Sanmpl
Sampling Set relay for sampling operation
OFF
Off
Disable relay and front panel status LED
(Select Off to enable Interlock feature)
Preset
Preset
Set batch preset
Set 1
Set 1
Program set point 1
RSt 1
Reset 1 Program reset point 1
RLY 2
Relay 2
Relays 2-4 setup
FaiLSF
Fail-safe
Enter
Fail-safe
menu
FLS 1
Fail-safe 1 Set relay 1 fail-safe operation
on
On
Enable fail-safe operation
off
Off
Disable fail-safe operation
FLS 2
Fail-safe 2 Set relays 2-8 fail-safe operation
DeLAY
Delay
Enter relay
Time Delay
menu
DLY 1
Delay 1 Enter relay 1 time delay setup
On 1
On 1
Set relay 1 On time delay
OFF 1
Off 1
Set relay 1 Off time delay
DLY 2
Delay 2 Enter relays 2-8 time delay setup
break
Loop break
Set relay condition if loop break detected
ignore
Ignore
Ignore loop break condition (Processed as a low signal condition)
On
On Relay goes to alarm condition when loop break is detected
Off
Off
Relay goes to non-alarm condition when loop break is detected
Aout
Analog output
Enter the
Analog output
scaling menu
Dis 1
Display 1 Program display 1 value
Out 1
Output 1
Program output 1 value (e.g. 4.000 mA)
Dis 2
Display 2 Program display 2 value
Out 2
Output 2 Program output 2 value (e.g. 20.000 mA)
3
During operation, only the STOP button will function, to stop/pause the batch. As a result, relay alarms cannot be
manually reset.
4
This setting used for level control applications. It is not appropriate if using this controller for batching applications.
www.calcert.com sales@calcert.com 1.888.610.7664
0
5
10
15
20
25
30