ProtEX-MAX PD8-6200 Explosion-Proof Analog Input Rate/Totalizer Instruction Manual
25
Display Functions and Messages
The meter displays various functions and messages during setup, programming, and operation. The
following table shows the main menu functions and messages in the order they appear in the menu.
Display
Parameter Action/Setting
setup
Setup
Enter
Setup
menu
Input
Input
Enter
Input
selection menu
mA
4-20 mA
Set meter for 4-20 mA
input
volt
0-10 VDC
Set meter for
10 VDC
input
Total
Total
Enable or disable totalizer
features
d-SCAL
Dual-scale
Enter
d-SCAL
menu and
select
Yes
for dual- scale
or
No
for single scale
display
units
Units
Select the display
units/tags
rate
Rate
Select the display units for
rate
total
Total
Select the display units for
total
Gtotal
Grand
Total
Select the display units for
grand total
Dec pt
Decimal
point
Set decimal point for rate,
total, grand total
prog
Program
Enter the
Program
menu
InCAL
Input
Calibration
Enter the
Input Calibration
menu
sCalE
Scale
Enter the
Scale
menu
Cal
Calibrate
Enter the
Calibrate
menu
Inp 1
Input 1
Calibrate input 1 signal or
program input 1 value
Dis 1
Display 1
Program display 1 value
Inp 2
Input 2
Calibrate input 2 signal or
program input 2 value (up
to 32 points)
Dis 2
Display 2
Program display 2 value
(up to 32 points)
Error
Error
Error, calibration not
successful, check signal or
programmed value
T tb
Total time
base
Program total time base
T CF
Total
conversion
factor
Program total conversion
factor
T rst
Total reset
Program total rest mode:
auto or manual
Display
Parameter Action/Setting
GT tb
Grand total
time base
Program grand total time
base
GT CF
Grand total
conversion
factor
Program grand total
conversion factor
GT rst
Grand total
reset
Program grand total rest
mode: auto or manual
Auto
Automatic
Press Enter to set
automatic total reset
T dly
Time delay
Program time delay for
total auto reset
mAn
Manual
Press Enter to reset total
manually
dsplay
Display
Enter the
Display
menu
Line 1
Line 1
Press Enter to assign the
Main display parameter
(default: PV or rate)
Line 2
Line 2
Press Enter to assign the
small display parameter
(default: total)
d-Inty
Display
intensity
Set display intensity level
from 1 to 8
RELaY
Relay
Enter the
Relay
menu
Assign
Assignmen
t
Assign relays to rate, total,
or grand total
Asign1
Assign 1
Relay 1 assignment
totAL
Total
Assign relay to total
G total
Grand total
Assign relay to grand total
m bus
Modbus
Select to display Modbus
input or to assign Modbus
input as the analog output
source
rate
Rate
Assign relay to rate
RLY 1
Relay 1
Relay 1 setup
Act 1
Action 1
Set relay 1 action
Auto
Automatic
Set relay for automatic
reset
A-nman
Auto-
manual
Set relay for automatic &
manual reset
any time
LatCH
Latching
Set relay for latching
operation (relays assigned
to rate)
www.
GlobalTestSupply
.com
Find Quality Products Online at:
