Faults
43
Symptom
Possible cause
Corrective actions
Triggering without a
fastener being driven in
(blank firing).
The spring of the
pusher is defective.
Contact customer service
(see page 48).
The magazine is dirty.
Clean the magazine.
Wrong fasteners are
loaded in the
magazine.
Empty the magazine.
Fill the magazine with
PREBENA fasteners
(from page 20).
The stapler unit is not
sufficiently lubricated.
Fill PREBENA special
nailer oil into used
compressed air supply.
Trigger a few times.
The operating
pressure is too low.
Increase operating
pressure (see page 17).
The piston with the
driver is not returned to
the initial position after
the stapling operation.
Contact customer service
(see page 48).
The triggering process
is not completed.
Contact customer service
(see page 48).
The driver is bent.
Contact customer service
(see page 48).
A fastener is jammed.
Remove jammed
fasteners (see page 40).
Otherwise, contact
customer service (see
page 48).
If despite all that you cannot eliminate the fault, contact your dealer
or the manufacturer (see page 48).
Summary of Contents for KTVH-B19D
