Faults
40
Faults
WARNING
When operating a damaged or faulty stapler
unit serious or fatal injuries may occur.
Disconnect the stapler unit immediately
from the compressed air supply in case of
fault (see page 33).
Empty the magazine (see page 33).
Use the stapler unit only when the problem
is resolved.
ATTENTION
The stapler unit can be damaged by unauthorized people during
repairs.
Make sure that repairs to the stapler unit are only performed
by the manufacturer.
Remove jammed fasteners
To remove a jammed fastener, proceed as follows:
Disconnect the stapler unit from the compressed air supply (see
page 33).
Empty the magazine (see page 33).
Pull back the pusher and snap it on.
Loosen the jam in the device with a thin pair of pliers or a
screwdriver
Move the pusher again carefully into position.
Remove the jammed or deformed fasteners.
Connect the compressed air supply (see page 17).
Fill the magazine as described on page 20.
Check the functioning of the stapler unit (see page 24).
If you cannot eliminate the fault, contact your dealer or the
manufacturer (see page 48).
Summary of Contents for KTVH-B19D
