FRA ENG
ITA
ESP DEU POR
4 / 6
5.2 Learning of the transmitter on the second relay of the receiver
3
4
6
Release the key of the transmitter
Press and keep pressed
the key present on
the receiver.
DO NOT
release the key on the receiver.
The receiver emits
2
bips.
The learning ended correctly.
1
Check that the DIP 3 and 4 of the
transmitter and of the receiver are set in the
same way.
Press and keep pressed
the key present on
the transmitter.
The receiver emits
2
bips.
5
Release
the key on the receiver.
NOTE: in case in which instead 4 BIP are reproduced, it means that the maximum number of transmitters for the selected channel has been
reached and that no new devices on the same relay can be memorized.
In case in which a device previously memorized is then associated to the other relay, it will be automatically removed from the previous relay.
For example, if a device memorized on the relay 1 is memorized on the relay 2 it will be automatically removed from the relay 1.
Acoustic signalling during the learning phase
Number of BIP
Meaning
2
Transmitter correctly memorized
4
Mistake : the maximum number of transmitter for selected channel has been reached
1
Maximum time up for the memorization of the transmitter (10 second)
5.3 Summary of the acoustic signalling during the learning phase
Beside the two receiver relays a jumper for the selection of the type signal to give on output is present. This signal can be:
1.
A clean contact : open contact in case of alarm and close if the alarm is not present
2.
A contact type 8,2K : resistance of the contact = 0 or ∞ (Open loop) Ohm in case of alarm and 8,2K
Ω
if the alarm is not present. The control
unit connected to the device must be able to handle this type of signal.
The selection of the type of signal is carried out in the following way:
Jumper Pos. 1
Jumper Pos. 2
Position 1 : clean contact functioning (Mec)
Position 2 : 8K2 functioning (8,2K)
6. SELECTION OF THE TYPE OF SIGNAL ON OUTPUT RELAY
2
MEC.
8K2
2
3
4
Press and keep pressed
the key present on
the receiver.
Release
the key on the receiver.
1
5. LEARNING
5.1 Learning of the transmitters on the first relay of the receiver
Check that the DIP 3 and 4 of the transmitter
and of the receiver are set in the same way.
Press and keep pressed
the key present on
the transmitter.
Release the key of the transmitter
5
The receiver emits
1
bip
The receiver emits
1
bip
The receiver emits
2
bips.
The learning ended correctly.
For the successive learning, repeat the operation from point 1.
