PR XR330 BWS, Instruction Manual

Page: 17 / 24

17/24
193-255 Rotation(Anti- Clockwise from slow to fast)
15 17 20 Frost Filter
000-255
Linear Frost
16 18 21
Focusing
000-255
Linear Focusing
22 Focusing Fine
000-255
Focusing in 16 bit precision
17 19 23 Zoom
000-255
Linear Zooming
24 Zooming Fine
000-255
Linear Zooming in 16 bit precision
18 20 25 Diffuser
000-016
Open
017-255 Diffuser
19 21 26 Pan 000-255 Pan(0°~540°)
22 27 Pan Fine 000-255 Pan in 16 bit precision
20 23 28
Tilt 000-255 Tilt(0°~270°)
24 29 Tilt Fine 000-255 Tilt in 16 bit precision
25 30 Pan & Tilt Speeds 000-255 Pan & Tilt Speed from Fast to Slow
21 26 31
Control
000-047 Reserved
048-080 Reset
081-112 Reserved
113-144 Lamp Off ( Delay for 3 s)
145-168 Reserved
169-200 Lamp Half Power
201-223 Reserved
224-255 Lamp Full Power
Remark: Prism is prior to Frost
LED INDICATION
DMX Indication
On DMX signal OK
Off No DMX signal
Flash DMX signal error
W-DMX Indication
ON Wireless DMX Signal available
OFF Not linked to any transmitter
Flash Lose link with a transmitter or being linked with one
MAINTENANCE
If the projector’s lens becomes damaged or broken it should be replaced. If the lamp becomes damaged or deformed in any way it
must be replaced. If the light from the lamp appears dim this would normally indicate that it is reaching the end of its life and it should
be changed at once, aged lamps run to the extremity of their life might explode. If the projector does not function, check the fuses on
the power socket of the projector, they should only be replaced by fuses of the same specification. The projector has overheat
protection device that will switch off the projector in case of overheating. Should it happen, check if the fans are blocked or not, or if
they are dirty, clean them before switching on the projector again.
Any maintenance work should only be carried out by qualified technicians.
LUBRICATION
To ensure the smooth rotation of the rotating gobos and movement of the lens for focusing, it is recommended that the bearings for
the rotating gobos and the 2 sliding tracks for the focusing lens holder be lubricated every two months. Use only high quality,
high-temperature grease .