PR XR330 BWS, Instruction Manual

Page: 4 / 24

4/24
INSTALL THE PROJECTOR
Warning
please run the safety cord
through the two holes for safety
!
Safety cord
Handle
Clamp
Control menu
Take 2 clamps and the safety cord out from the package and mount 2 clamps on the underside of fixture with 2 retainers attached to
each clamp. Hang the fixture on the structure and fasten the screws attached to each clamp. (See the
WARNING on the underside of
the base as shown above) To pass the SAFETY CORD through the HOLES for safety! Always ensure that the projector is firmly
anchored to avoid vibration and slipping whilst functioning. Always ensure that the structure that you are going to mount the projector
to is secure and strong enough to support the weight of a XR 1000 Framing
WARNING:
1. The projector MUST be lifted or carried by the HANDLES instead of clamps.
2. For safety the safety cord should afford 10 times the Projector’s weight.
FITTING THE LAMP
Lock the yoke before
fitting/replacing
the lamp. Just as
Shown by Figure 1,
after Opening the
cover at the rear of
the
projector by
loosening 8 fastfit
screws, you can open
the head. To adjust
the lamp as per
Figure 2. Take out
the lamp as per the
figure 3.
Before
lamp
installation, tighten
its power wires well.
Lamp in and out are
opposite orders
Note: don’t touch the
internal surface of
the reflector and
the burner of the lamp with bare hands so as not to impair the beam output.
Important: Always read "Instructions for use" enclosed with the lamp.
1.
loosen 4 screws at the fan's
two side
2.
loosen a tightening
screw by a cross screw
driver at the lamp's side
2. Remove the lamp's two
wires and push it obliquely
for the removal.
Figure2
：
lamp adjustment
Figure3
：
removal of lamp Figure 1
:
loosen 8pcs of fastfit screws
3.
to adjust the two screws by a
cross screw driver to change the
lamp's position
1.loosen a tightening
screw @ the lamp's side