Issue
1
1 947079
Issue 2
VIP-430
TALKBACK IP WALL SPEAKER
INTRODUCTION
The VIP-430 Talkback IP Wall Speaker enables
handsfree talkback access to a single location over
an IP-based LAN/WAN. This allows a handsfree
talkback extension anywhere on the network. The
speaker levels are electrically adjusted during
setup. The enclosure is made of steel with a
durable gray powder coated finish. The color of the
enclosure can easily be changed to match any
decor. A detachable black clothe grille is included.
A call switch input is provided for the remote
speaker location signaling.
Power is provided to the VIP-430 via a Power over
Ethernet switch meeting the 802.3af specification.
INSTALLATION
FCC Information
This equipment has been tested and found to
comply with the limits for a Class A digital device,
pursuant to Part 15 of the FCC Rules. These limits
are designed to provide reasonable protection
against harmful interference when the equipment is
operated in a commercial environment. This
equipment generates, uses and can radiate radio
frequency energy and if not installed and used in
accordance with the instruction manual, may cause
harmful interference to radio communications.
Operation of this equipment in a residential area
may cause harmful interference in which case the
user will be required to correct the interference at
his own expense.
DIMENSIONS/WEIGHT
10.13” H x 12.31” W x 4.63” D
(25.73cm x 31.27cm W x 11.75cm D)
Weight: 4.25 LBS (1.91 kg)
Environment
Temperature: 0 to +40° C
Humidity:
0 to 85% non-precipitating
Precautionary Designations
CAUTION: To reduce the risk of electric shock,
Do not remove cover.
No user serviceable parts inside.
Refer servicing to qualified serv ice personnel.
CAUTION
RISK OF ELECTRIC SHOCK
DO NOT OPEN
This symbol indicates that dangerous
voltage constituting a risk of electric
shock is present within this unit.
This symbol indicates that there are
important operating and maintenance
instructions in the literature accompanying
this unit.
Packing List
Qty. Item
1 VIP-430
1 VSP
Document
MOUNTING
Remove the screw holding the mounting bracket to
the enclosure. Mount the bracket using appropriate
hardware such as #8 pan head crews. After
making the required connections, reattach the
enclosure to the mounting bracket
Network Connection
The VIP-430 has one RJ-45 network connector on
the rear panel. Use a standard Ethernet patch cable
to connect the VIP-430 to an Ethernet switch.
Call Switch Connection
The VIP-430 provides a call switch input via screw
terminal connections. See Fig.1 for details.
