PR Lighting XR 230 SPOT PR-2200, User Manual

Page: 17 / 23

17/23
23 29 Tilt Fine 000-255 Tilt in 16 bit precision
24 30
Pan & Tilt Speeds
000-255
Pan & Tilt Speed from Fast to Slow
20 25 31
Control
000-047 Reserved
048-080
Reset
081-112 Reserved
113-144
Lamp Off ( Delay for 3 s)
145-168
Reserved
169-200
Lamp Half Power
201-223 Reserved
224-255
Lamp Full Power
Prism is prior to Frost Filter.
MAINTENANCE
If the projector’s lens becomes damaged or broken it should be replaced. If the lamp becomes damaged or deformed in any way it must
be replaced. If the light from the lamp appears dim this would normally indicate that it is reaching the end of its life and it should be
changed at once, aged lamps run to the extremity of their life might explode. If the projector does not function, check the fuses on the
power socket of the projector, they should only be replaced by fuses of the same specification. The projector has overheat protection
device that will switch off the projector in case of overheating. Should it happen, check if the fans are blocked or not, or if they are dirty,
clean them before switching on the projector again.
Any maintenance work should only be carried out by qualified technicians.
LUBRICATION
To ensure the smooth rotation of the rotating gobos and movement of the lens for focusing, it is recommended that the bearings for the
rotating gobos and the 2 sliding tracks for the focusing lens holder be lubricated every two months. Use only high quality,
high-temperature grease .
KEEPING THE PROJECTOR CLEAN
To ensure the reliability of the projector it should be kept clean. It is recommended that the fans should be cleaned every 15 days. The
lens and dichroic colour filters should also be regularly cleaned to maintain an optimum light output. Do NOT use any type of solvent
containing chemical elements on dichroic colour filters.
Cleaning frequency depends on the environment in which the fixture operates. A soft cloth and typical glass cleaning products should
be used in cleaning. It is recommended to clean the external optics at least once every 20 days and clean the internal optics at least once
every 30 / 60 days.
Do not use any organic solvent, e.g. alcohol, to clean the reflector mirror, dichroic colour filters or housing of the apparatus.
TROUBLESHOOTING
PROBLEM ACTION
The projector doesn’t switch on

Check the fuse on the power socket.

Check the lamp.
The lamp is on but the projector doesn’t respond
to the controller

Make sure that the fixture’s start address is right

Replace or repair the XLR signal cable.
The projector functions intermittently

Make sure the fan is working well or fans and their shields are not blocked
Beam appears dim, Low in brightness

Make sure the lamp is within its lifespan

Remove dust or grease from the lenses.
The project image appears to have a halo

Carefully clean the lamp, optical lenses and other components.
Heavily Defective Beam

Check if lens are in good condition(not cracked)

Clean dust or grease on the lens.