PR Lighting XR 230 SPOT PR-2200, User Manual

Page: 7 / 23

7/23
STAND-ALONE MODE
Operate the projector without connecting a controller, enable the master mode in the operation panel, the projector will
run in Stand-Alone mode automatically.
MASTER/SLAVE MODE
Without using a controller, many projectors can run synchronously in the Master/Slave mode by linking them with each
other. Connect the controller’s output to the first fixture’s input, and connect the first fixture’s output to the second fixture’s input and
connect the rest fixtures in the same way. Eventually connect the last fixture’s output to a DMX terminator as shown in the figure below.
Then the first one is the master with setting options as master mode enabled, and others are slaves.
Start Address for all slaves is 001. The Master can run at any mode for the Master and Slaves run at the corresponding
mode compared to the Master.
After powered , the group will run at Master/Slave Mode.
.
OPERATION MENU
First Menu Secondary Menu Third Menu Fourth Menu
DMX Address
XXX
（
XXX:1~449
）
Reset Are You Sure
Config Settings
DMX Mode
（
Default
：
Standard
）
Standard
Extended
Short
Lamp Control
By Control Channel
By Power On
By DMX Present
Loss of DMX
When DMX is Lost Normal Time out
When DMX is Lost Hold Last value
Fan Operate Mode
Fan Operate Mode
Normal
Quieter
Hot Environment
Factory Settings
(Press button
DOWN/UP/ENTER at the same
time to enter the sub-menu)
Fixture Type
(WARNING: Never change the
fixture type or the fixture will be
damaged!)
INPUT OUTPUT
MASTER SLAVE SLAVE
INPUT OUTPUT INPUT
DMX TERMINATOR