4/22
INSTALL THE PROJECTOR
Take 2 clamps and the safety cord out from the package and mount 2 clamps on the underside of fixture with 2 retainers attached to
each clamp. Hang the fixture on the structure and fasten the screws attached to each clamp. (See the
WARNING
on the underside of
the base as shown above)
To pass the SAFETY CORD through the HOLES for safety!
Always ensure that the projector is firmly
anchored to avoid vibration and slipping whilst functioning. Always ensure that the structure that you are going to mount the projector
to is secure and strong enough to support the weight of a XR 1000 Framing
WARNING:
1. The projector MUST be lifted or carried by the HANDLES instead of clamps.
2. For safety the safety cord should afford 10 times the Projector’s weight.
FITTING THE LAMP
Lock the yoke before fitting/replacing the lamp.
Just as Shown by Figure 1, after Opening the cover at the rear of the projector by loosening 4 fastfit screws, you can see the structure
as shown in the figure 2 on the right.
Hold the bottom of a lamp while taking it out, then loosen the lamp anti-clockwise and pull it out from the rear of a projector. Lamp
installation and Take-out are in reverse orders.
Note:
don’t touch the bulb of the new lamp with bare hands so as not to impair the beam output.
Close the rear cover and fasten 4 fastfit screws.
Important: Always read "Instructions for use" enclosed with the lamp.
FIGURE 1
4
FASTFIT
SCEWS
LAMP
FIGURE 2
